How To Wire An Electrical Outlet In Series
As a homeowner in the zip code 02907 of Cranston Providence, Rhode Island, you understand the importance of maintaining your property. From regular maintenance to tackling DIY projects, you take pride in keeping your home safe and functional. However, when it comes to electrical work, it’s always best to leave it to the professionals.
That’s where B&K Electric comes in. As a family-owned and operated electrical business based in Warwick, RI, B&K Electric has been proudly serving the Cranston, Warwick, and all of Rhode Island community for over seventeen years. With a focus on community and customer service, our licensed electricians specialize in electrical repair, panel maintenance, and installation.
In this article, we will provide a step-by-step guide on how to wire an electrical outlet in series. This guide is intended for the homeowners in Cranston, Providence, and the greater Providence area who are looking for a licensed electrician for servicing their residence. So, let’s get started!
Step 1: Gather the Necessary Tools and Materials
Before beginning any electrical work, it’s important to gather all the necessary tools and materials. For this project, you will need:
– Wire strippers
– Wire cutters
– Electrical tape
– Electrical outlet
– Black wire (hot)
– White wire (neutral)
– Grounding wire (bare copper)
Step 2: Turn off the Power
Safety should always be your top priority when working with electricity. Before starting any electrical project, it’s crucial to turn off the power to the area you will be working on. If you’re not sure which breaker controls the particular outlet you will be working on, turn off the main power supply.
Step 3: Take Out the Old Outlet
Once you have turned off the power, it’s time to remove the old outlet. Using your screwdriver, unscrew the faceplate and remove it. Then, unscrew the outlet from the electrical box and gently pull it out.
Step 4: Identify the Hot and Neutral Wires
Inside the outlet, you will see three wires – a black wire (hot), a white wire (neutral), and a grounding wire (bare copper). Use your multi-meter to identify the hot and neutral wires. The black wire should indicate a higher voltage than the white wire.
Step 5: Install the New Outlet
After identifying the hot and neutral wires, it’s time to install the new outlet. Begin by attaching the grounding wire to the green screw on the outlet. Then, connect the black (hot) wire to the brass screw on the outlet and the white (neutral) wire to the silver screw.
Step 6: Test the Outlet
Once the outlet is securely attached, use your multi-meter to test if it’s working properly. Turn the power back on and insert the probes into the top holes of the outlet. If the voltage reads between 110-120 volts, your outlet is working correctly.
Step 7: Wire the Outlets in Series
Now that the first outlet is wired, it’s time to wire the remaining outlets in series. To do this, you will need to connect the black (hot) wire from the first outlet to the black (hot) wire of the second outlet. Repeat this step for the neutral (white) and grounding (bare copper) wires. This creates a continuous circuit for the electricity to flow through.
Step 8: Test the Outlets in Series
Once all outlets are wired in series, it’s time to test them. Use your multi-meter to check the voltage at each outlet. If the voltage reads between 110-120 volts, your outlets are correctly wired in series.
Step 9: Secure the Outlets
Lastly, secure the outlets in place by screwing them into the electrical box and attaching the faceplate. Turn on the power to the circuit and test each outlet to ensure they are all working correctly.
Wiring outlets in series may seem like an intimidating task, but by following these simple steps, you can safely and efficiently wire an electrical outlet in series. Remember to always prioritize safety when working with electricity and to hire a licensed electrician if you’re not confident in your abilities.